Emerson PMAC II Solo, Installation And Operation Manual

Page: 17 / 22

Programming the UC12PG-R Controller on the PMAC II Solo Panel Overview • 11
sweat heaters and input values. The UC12PG-R also aver-
ages and logs heater run times, and displays hourly, daily,
weekly, and monthly run time averages.
1.5.7.1. Viewing Status Screens
1. Log into the UC12PG-R as instructed in Sec-
tion 1.5.3.,
Logging Into the UC12PG-R
.
2. The Main Configuration screen should be
visible (
Figure 1-12
). Use the and
buttons to move the cursor to 1. STATUS .
Press the button to select and open the
first Status screen.
3. From the Status View screen, press the
button to move the cursor to 1. VIEW TIME
& DATE and press the button to select
and view.
This screen displays the current date and time of the
controller.
4. Press the or button to go back to the
Status View screen.
5. From the Status View screen, press the
button to move the cursor to 2. VIEW
SPACE TEMP and press the button to
select and view.
This screen displays the current space temperature.
6. Press the or button to go back to the
Status View screen.
7. From the Status View screen, press the
button to move the cursor to 3. VIEW DEW-
POINT and press the button to select
and view.
This screen displays the current inside dewpoint tem-
perature.
8. Press the or button to go back to the
Status View screen.
Figure 1-39 - Status View Screen (First Screen)
Figure 1-40 - Complete Status View Menu
NOTE: Only four lines at a time are visible
through the PMAC II Solo keypad window.
1.VIEW TIME & DATE
2.VIEW SPACE TEMP
3.VIEW DEWPOINT
4.VIEW MIN DEWPOINT
1.VIEW TIME & DATE
2.VIEW SPACE TEMP
3.VIEW DEWPOINT
4.VIEW MIN DEWPOINT
5.VIEW MAX DEWPOINT
6.VIEW MIN PULSE %
7.VIEW MAX PULSE %
8.VIEW LOAD SHED
9.VIEW LOAD SHED %
10.SOTWARE VERSION
Figure 1-41 - Time and Date Status Screen
Figure 1-42 - Time and Date Status Screen
Figure 1-43 - Dewpoint Status Screen
00 / 00 / 00
00 : 00 : 00
SPACE TEMP
84F
DEW POINT
77F