RSTI-EP PROFINET I/O Controller User Manual
Section 2
GFK-2571R
May 2021
Installation
40
Typical SFP Modules
Below are images of the two types of Ethernet SFPs. The Single- and Multi-Mode Fiber SFPs
accept an LC Connector. The Copper SFPs accept an RJ45 connector
Figure 29: Fiber SFP showing LC Connector
Figure 30: Copper SFP showing RJ45 Connector
2.7.4
Removing SFP Devices
WARNING
If the surrounding air operating temperature of the PNC001 module is greater than 40°C
(104°F), SFP devices could reach operating temperatures over 70°C (158°F). Under these
conditions, for your safety, do not use bare hands to remove an SFP device from the SFP
cage. Use protective gloves or a tool (needle-nose pliers) to avoid handling the hot SFP
device directly when removing the SFP device.
Remove the cable from the SFP device. If the device has a latching mechanism such as a bale
clasp, open it gently. Do not pull on the latching mechanism. Hold the sides of the SFP
device and pull it out of the PROFINET Controller port.
Summary of Contents for PACSystems RX3i
Page 46: ...RSTI EP PROFINET I O Controller User Manual Section 2 GFK 2571R May 2021 Installation 39 ...
Page 51: ...RSTI EP PROFINET I O Controller User Manual Section 2 GFK 2571R May 2021 Installation 44 ...
Page 72: ...RSTI EP PROFINET I O Controller User Manual Section 3 GFK 2571R May 2021 Configuration 65 ...
Page 82: ...RSTI EP PROFINET I O Controller User Manual Section 3 GFK 2571R May 2021 Configuration 75 ...