Emerson PACSystems RX3i, User Manual

Page: 11 / 164

RSTI-EP PROFINET I/O Controller User Manual Section 1
GFK-2571R May 2021
Introduction 4
The PNC001 supports 10/100/1000Mbps Copper,
100/1000Mbps
Multi-mode Fiber, and
100/1000Mbps Single-mode Fiber. The network can
include media interfaces of more than one type.
PROFINET communications on the network require
100 and 1000 Mbps link speed. 10Mbps cannot be
used for PROFINET communications. However,
10Mbps can be used for other types of Ethernet
traffic, such as ping, and telnet.
Features of the RX3i PNC001 module include:
• Full programming and configuration services for
the PROFINET Controller, PROFINET Scanners
(PNS), and other third-party IO-Devices using
PAC Machine Edition.
• Firmware upgrades using the WinLoader
software utility.
• Built-in Command Line Interface function that
provides direct monitoring and partial
configuration via the module’s micro USB port or
using telnet. (PNC001-Ax only)
Note:
The USB port is for system set-up and
diagnostics only.
It is not intended for permanent connection.
• Support for star, ring, and daisy-chain/line
network topologies.
• Four switched Ethernet ports — two 8-
conductor RJ45 shielded twisted pair
10/100/1000 Mbps copper interfaces and two
Small Form-factor Pluggable (SFP) cages for
user-supplied SFP devices.
• Support for media redundancy
• Internal clock synchronized with the RX3i CPU
for time-stamped diagnostics entries.
• Restart pushbutton to manually restart the
module without power cycling the system.
• LEDs: OK, LAN, STATUS, CONFIG, ACTIVE, USB
(PNC001-Ax only), and Port Number LEDs as
shown in Figure 2 and Figure 3.
Figure 1: IC695PNC001-Bxxx
Front View