Emerson MICRO MOTION 2700, Configuration And Use Manual, Page: 127 / 374

Typical discrete output circuit Figure 6-1:
A. 24 V (Nom)
B. 3.2 K
Ω
C. Out+
D. Out −
6.4.3 Configure Discrete Output Fault Action
Display
Not available
ProLink II ProLink > Configuration > Frequency/Discrete Output > Discrete Output > DO Fault Action
ProLink III
Device Tools
>
Configuration
>
Fault Processing
Field Communicator Configure > Manual Setup > Inputs/Outputs > Discrete Output > DO Fault Action
Overview
Discrete Output Fault Action
controls the behavior of the discrete output if the transmitter
encounters an internal fault condition.
Note
For some faults only: If Last Measured Value Timeout is set to a non-zero value, the transmitter will not
implement the fault action until the timeout has elapsed.
CAUTION!
Do not use
Discrete Output Fault Action
as a fault indicator. If you do, you may not be able to
distinguish a fault condition from a normal operating condition. If you want to use the discrete
output as a fault indicator, see
Fault indication with the discrete output .
Integrate the meter with the control system
Configuration and Use Manual 119