Emerson Micro-Motion 2400S, Configuration And Use Manual, Page: 180 / 198

172 Micro Motion
®
Model 2400S Transmitters with Analog Outputs
Menu Flowcharts – Model 2400S AN Transmitters
Figure C-13 Display menu – Maintenance – Configuration: I/O
OFF-LINE MAINT
Scroll and Select simultaneously
for 4 seconds
Scroll
Select
Select
Scroll
CONFG
MASS
UNITS
VOL
(1)
DENS
TEMPR
Select
Scroll
Scroll
Scroll
Scroll
PRESS
CH A
IO
4 MA
20 MA
Select
Scroll
Scroll
EXIT
SET FO
(2)
CH B
SRC
FREQ
Select
Select
Scroll
Scroll
EXIT
Scroll
Scroll
SRC
Select
Scroll
POWER
Scroll
SET DO
(2)
SRC
POLAR
Select
Scroll
Scroll
POWER
CONFIG FL SW
(3)
SETPOINT FL SW
(3)
SOURCE FL SW
(3)
Scroll
Scroll
Scroll
RATE
Scroll
POLAR
Scroll
POWER
Scroll
EXIT
Scroll
SET DI
(2)
POLAR
POWER
Select
Scroll
Scroll
ACT
EXIT
Scroll
Scroll
START ZERO
RESET MASS
RESET VOL
(4)
RESET ALL
START/STOP
EXIT
Scroll
Scroll
Scroll
Scroll
Scroll
Select
Select Scroll
Scroll
EXIT
(1) Either Vol or GSV is displayed, depending on Volume Flow Type. You
must use ProLink II to configure Volume Flow Type.
(2) A confirmation screen is displayed to accept or cancel the channel
assignment.
(3) This screen appears only if SRC is set to Flow Switch.
(4) Either Reset Vol or Reset GSV T is displayed, depending on Volume
Flow Type. You must use ProLink II to configure Volume Flow Type.