Emerson Micro-Motion 2400S, Configuration And Use Manual, Page: 178 / 198

170 Micro Motion
®
Model 2400S Transmitters with Analog Outputs
Menu Flowcharts – Model 2400S AN Transmitters
Figure C-10 Display menu – Managing totalizers and inventories
Figure C-11 Display menu – Off-line menu, top level
STOP/START (3)(4)
Select
Scroll
RESET (5)(6)
STOP/START YES?
Process variable
display
RESET YES?
Scroll
Mass total (1) Volume total 1)
Scroll
Select
E1--SP
(2)
Yes No
Select Scroll
E2--SP (2)
Scroll
EXIT
Select
Yes No
Select Scroll
Scroll Scroll
(1) The transmitter must be configured to allow resetting totalizers from the display. See Section 8.10.3.
(2) The transmitter must be configured to allow starting and stopping totalizers from the display. See Section 8.10.3.
(3) The Event Setpoint screens can be used to define or change the high setpoint (Setpoint A) for Event 1 or Event 2.
These screens are displayed only if the event is defined on mass total or volume total. Otherwise, the Scroll optical
switch takes the user directly to the Exit screen.
Scroll and Select simultaneously
for 4 seconds
VER
OFF-LINE MAINT
Select
SEE ALARM
Scroll
Scroll
Scroll
EXIT
CONFG
Scroll
SIM
Scroll
ZERO
Scroll
SENSOR VERFY
(1)
Scroll
EXIT
(1) This option is displayed only if the meter verification software is installed on the transmitter.