Emerson MCi210, User Manual

Page: 27 / 78

MCi210 User Guide
27
Issue Number: 2
Safety
in
form
ation
In
tro
duct
ion
M
echan
ical
in
st
all
ation
El
ec
tri
ca
l
in
stallation
Pa
ra
m
ete
rs
V
ariabl
e allo
ca
tion
menus
D
igi
ta
l I/O
Ti
m
e
r
Use
r
pr
og
ra
mmi
ng
Dia
gno
stics
Inde
x
When DHCP is enabled, the following parameters will become read-only immediately (no reset
required):
IP Address ( S.02.006 )
Subnet Mask ( S.02.007 )
Default Gateway ( S.02.008 )
Primary DNS ( S.02.009 )
Secondary DNS ( S.02.010 )
This parameter controls and displays the IP Address of the module.
If DHCP is enabled (
DHCP Enable ( S.02.005 )) this parameter becomes read-only and, until an IP
Address is allocated to the module, will display 0.0.0.0.
If DHCP is disabled the module will initialize, on reset or power cycle, with the IP Address stored for
the parameter.
This parameter controls and displays the subnet mask of the module.
If DHCP is enabled (
DHCP Enable ( S.02.005 )) this parameter becomes read-only and, until an IP
Address is allocated to the module, will display 0.0.0.0.
If DHCP is disabled the module will initialize, on reset or power cycle, with the subnet mask stored
for the parameter.
S.02.006 IP Address
Minimum 0 (Display: 0.0.0.0) Maximum
4294967295
(Display: 255.255.255.255)
Default
3232235876
(Display: 192.168.1.100)
Units
Type 32 Bit User Save Update Rate
DHCP enabled : write on
event; DHCP disabled :
read on reset
Display Format IP Address Decimal Places 0
Coding RW, BU
S.02.007 Subnet Mask
Minimum 0 (Display: 0.0.0.0) Maximum
4294967295
(Display:255.255.255.255)
Default
4294967040
(Display: 255.255.255.0)
Units
Type 32 Bit User Save Update Rate
DHCP enabled : write on
event; DHCP disabled :
read on reset
Display Format IP Address Decimal Places 0
Coding RW, BU