26 Chapter 3 Web Page Of RDU-SIC G2
RDU-SIC G2 Card User Manual
3.4.6 System Options
On the RDU-SIC G2 homepage, click the
System Options
menu in the left part, eight submenus appear, including:
Monitoring Unit
,
Network Setting
,
User Management
,
Date/Time Setting
,
Restore System
,
Site Setting
,
System
Upgrade
and
System Title
.
Monitoring Unit
The
Monitoring Unit
is used to set the signals of RDU-SIC G2 system, including
Sampling
,
Setting
and
Alarm
signals, the page is shown in Figure 3-44.
Figure 3-44 Monitoring unit (Sampling)
As for the operation method of the three tabs of
Sampling
,
Setting
and
Alarm
on the Monitoring unit page, refer to
3.4.1 Device Information
.
Note
On the
Setting
tab, if you set ‘Blocked’ for
Outgoing Alarm Blocked
, when an alarm occurs, it will be blocked, in this case:
1. For current alarms, the page only displays the alarm signals, but not send alarm notifications; after the alarm disappears, it will
not be saved in history alarm;
2. The ‘Blocked’ setting for
Outgoing Alarm Blocked
will be automatically cleared in 24h.
Network Setting
1. IP Setting
Click the
Network Setting
under the
System Options
menu, the page shown in Figure 3-45 pops up.
Figure 3-45 IP setting
On the page shown in Figure 3-45, you can configure the network parameters, such as IP addressing mode,
IP
,
Mask
,
GateWay
,
DNS1
(Preferred DNS server) and
DNS2
(Alternate DNS server). After modifying the network parameters,
click the
Save
button to make the setting effective.
Note
After modifying the IP address, the system will jump to the new IP address by default. You must use the new IP address to
re-login the RDU-SIC G2.
2. Access Management
Summary of Contents for Liebert Vertiv RDU-SIC G2
Page 2: ......
