Emerson Liebert Intellislot Unity Card, User Manual

Page: 32 / 92

Enable Communication Protocols
Liebert
®
IntelliSlot
™
Unity
™
Card User Manual 22
3.1.3 Enable SNMP
SNMPv1/v2c and SNMPv3 are enabled by default. The protocols may be configured or their default values
may be accepted. Authentication Traps are not enabled by default. The default Heartbeat Trap interval is
24 hours; this can be disabled or the interval may be changed.
1. Select the Communications tab > Protocols > SNMP .
2. Click Edit and enter a User name and password if required.
3. To enable Authentication Traps , click to check mark the box.
4. To change the Heartbeat Trap Interval , choose a time from the drop-down list or choose Disabled to
prevent any heartbeat traps from being sent.
• The interval times offered are 5 minutes, 30 minutes, or 1, 4, 8, 12 or 24 hours.
5. For each trap, choose whether or not to disable or set the interval to one of the periods on the menu.
For descriptions of the settings, refer to 5.5.3 - Protocols—SNMP Folder .
6. Click Save to confirm the changes or Cancel to discard them.
7. Restart the card to activate the changes.
a. Select the Communications tab > Support .
b. Enable the commands.
c. Click Restart .
Figure 3-7 SNMP