5
To reduce the risk of fire, electric
shock, or personal injury, mount fan
to outlet box marked “Acceptable for
Fan Support”, and use screws sup-
plied with outlet box. Most outlet
boxes commonly used for support of
light fixtures are not acceptable for
fan support and may need to be
replaced. Consult a qualified electri-
cian if in doubt.
!
WARNING
Turning off wall switch is not suffi-
cient. To avoid possible electrical
shock, be sure electricity is turned off
at the main fuse box before wiring. All
wiring must be in accordance with
National and Local codes and the ceil-
ing fan must be properly grounded as
a precaution against possible electri-
cal shock.
!
WARNING
To avoid possible fire or shock, fol-
low all wiring instructions carefully.
Any electrical work not described in
these instructions should be done or
approved by a licensed electrician.
!
WARNING
If your fan is to replace an existing ceiling
light fixture, turn electricity off at the main
fuse box at this time and remove the exist-
ing light fixture.
U.L. Model No.: CF205
12V BATTERY
WALL
CONTROL
COVER
SW102 WALL
CONTROL
HI
HI
MED
MED
LOW
LOW
FAN OFF
LIGHT
Figure 2
3.
Install the wall control onto the outlet
box using the supplied screws
(Figure 3).
4.
Install a decorator wall plate (pur-
chased separately) using the two
screws provided (Figure 3).
SW102 WALL
CONTROL
DECORATIVE WALL PLATE
(Purchased Separately)
OUTLET BOX
WALL PLATE
SCREW (2)
WALL CONTROL
SCREW (2)
REV
HI
MED
LOW
FAN OFF
LIGHT
Figure 3
Electrical Requirements
Your new ceiling fan will require a ground-
ed electrical supply line of 120 volts AC,
60 Hz, 15 amp circuit.
The outlet box must be securely anchored
and capable of withstanding a load of at
least 50 pounds.
BP7375 Highpointe 12/9/08 11:08 AM Page 5