Emerson GW-810-3760, Installation And Operation Manual

Page: 43 / 88

36 • RLDS I&O Manual 026-1309 Rev 11
1. Press the ENTER key to adjust the setting.
2. Use the LEFT/RIGHT cursor keys to move
across the entry field and the UP/DOWN
cursor keys to modify the individual
characters.
3. Press ENTER to accept the new entry or select
ESC to revert to the previous setting.
6.13. Re-Zero Mode
This parameter defines the frequency at which the
instrument re-zeros the optical sensor.
1. Press the ENTER key to adjust the setting.
2. Use the UP/DOWN cursor keys to toggle
between settings.
AUTO - sets the instrument to re-zero every 10
minutes.
ZONE CHANGE - sets the instrument to re-zero at
each zone change. This is the most accurate setting,
but increases the time interval between measurement
cycles.
3. Press ENTER to accept the new entry or ESC
to revert to the previous setting.
6.14. Navigating to the Third
Setup Screen
From the second System Setup screen 2 , select the
MORE option to go to the System Setup screen 3 .
Select the BACK option to return to the System Setup
screen 2 .
6.15.Baud Rate
This parameter defines the baud rate for the RS-485
communications port.
1. Press the ENTER key to adjust the setting.
2. Use the cursor keys to scroll through a list of
available baud rates to select the desired baud
rate.
3. Press ENTER to accept the new entry or ESC
to revert to the previous setting.
6.16. Node Address
Each RLDS on the network must have a distinct node
address. The node address may be set from 1 to 64.
NOTE: Both LOOP MODE (for selecting
track zones or highest PPM mode) as well
as the LOOP2 FACTOR (for scaling the
PPM output) are configured from the
SETUP menu. Configure one, then press ENTER to
access the other.
Figure 6-5 - Setup Screen 3
NOTE: The RS485 BAUD rate text will be
replaced by “Service Timeout” when in Service
Mode.