6.
Screw two 1” threaded studs (supplied) into the
motor (Figure 4). Leave approximately 7/8” of the
stud extending above the motor. Slide the motor
cover over the downrod and rotate the cover until the
threaded studs protrude; install two lockwashers and
knurled knobs (supplied) to secure the cover.
NOTE: Make sure the connected red leads, the
connected brown leads, and the white lead are
completely inside the motor cover and not pinched
between the motor cover and the motor.
7.
If you have installed the 18” downrod, install the
downrod trim and decorative bulb as follows (Figure
5). Slide the decorative trim (grommet-end first) over
the downrod and seat the grommet firmly against the
motor cover. Then slide the decora-tive bulb
(oriented as shown) over the down-rod, being certain
that the downrod trim seats in the bottom grommet of
the decorative bulb.
8.
Position the ceiling cover trim and the ceiling cover
over the downrod. Be sure the cover is oriented
correctly, with the large opening at the top
(Figure 5).
9.
Reinstall the hanger ball on the downrod (Figure 6)
as follows. Route the motor leads through the
hanger ball and slide the hanger ball over the
downrod. Install the pin through the holes at top of
the downrod and slide the hanger ball up the
downrod, aligning the ball so the pin is captured in
the groove in the top of the hanger ball. Pull the
hanger ball up tight against the pin and securely
tighten the setscrew in the hanger ball. A loose
setscrew could create fan wobble.
MOTOR COVER
KNURLED
KNOB
1"
THREADED
STUD
7/8"
LOCKWASHER
MOTOR
Figure 4
DOWNROD
CEILING
COVER
PIN
HANGER BALL
Figure 6
18" DOWNROD
GROMMET
DECORATIVE
BULB
GROMMET
DOWNROD
TRIM
GROMMET
MOTOR COVER
Figure 5
6
U.L. Model No.: CF1
Ceiling Fan Assembly
(continued)
Summary of Contents for CORNERSTONE CF1AB01
Page 18: ...18 U L Model No CF1 Notes ...
