Emerson Copeland EazyCool OME-4MTL-09X, Application Manuallines

Page: 23 / 71

18 C6.1.11/0718-0619/E
2.9.5 How to check the values of analog outputs
1) Enter the "Service" menu
2) Use the UP and DOWN keys to select the "Analog outputs" sub-menu
3) Press ENTER
Figure 23: iPro "Analog outputs" screen
Analog
output
Factory setting Description
Wiring
diagram
Function
AOC1 2 - 0-10V output inverter 1 suction
– Circuit 1
VF Drive M200 X1: 25 / 21 OUT1
AOC2 5 - 0-10V output inverter condenser
– Circuit 1
Fan speed X1: 25 / 22 OUT2
AOC3 0 - Not used Reserved X1: 25 / 23 OUT3
AOC4 0 - Not used
AOC5 0 - Not used
AOC6 0 - Not used
Table 11: Analog outputs overview
2.9.6 How to check the status of the relays / loads
1) Enter the "Service" menu
2) Use the UP and DOWN keys to select the "Loads status" sub-menu
3) Press ENTER . The "Loads status" sub-menu displays the status of the of the relays in the
following format:
Figure 24: iPro "Loads status" screen
Digital
output
Factory setting Description
Wiring
diagram
Function
DOC1
C1 - Inverter 1
suction - Circuit 1
Compressor (VF drive) on
– Signal "Run"
X1: 71 / 70 RL1 OA1
DOC2 0 - Not used X1: 71 / 72 RL2 OA2
DOC3 0 - Not used X1: 71 / 73 RL3 OA3
DOC4 46 - Alarm ALR1
– Alarm / Level 1
X1: 80 / 76 RL4 OA4
DOC5 0 - Not used ALR2
– Alarm / Level 2
X1: 80 / 77 RL5 OA5
DOC6 0 - Not used ALR
– General alarm / Active if ALR1 or ALR2
X1: 80 / 78 RL6 OA6
DOC7 0 - Not used X1: 80 / 79 RL7 OA7
DOC8 0 - Not used X1: 80 / 81 RL8 OA8
DOC9
C58 - Inverter
free - Circuit 1
For fan DI
– Delay adjustable
X1: 86 / 84 RL9 OA9
DOC10 0 - Not used X1: 86 / 85 RL10 OA10
DOC11
C49 - Auxiliary
output 1
Compressor heater X1: 90 / 87 RL11 OA11
DOC12 0 - Not used Reserved (heat recovery, solenoid control) X1: 90 / 88 RL12 OA12
DOC13 0 - Not used Reserved (heat recovery, solenoid control) X1: 90 / 89 RL13 OA13
DOC14 0 - Not used Reserved (heat recovery, solenoid control) X1: 90 / 91 RL14 OA14
DOC15 0 - Not used X1: 90 / 92 RL15 OA15
Table 12: Digital outputs