9
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: CF765-1
3. Ceiling Fan Assembly
(Continued)
CEILING COVER
PIN
HANGER
BALL
SETSCREW
DOWNROD
Figure 10
3.10
Route the Two 80” Motor Wires through the Hanger
Ball.
Reinstall the Hanger Ball on the Downrod, as follows:
Position the Hanger Ball Pin through the two Holes in
the Downrod and align the Ball so the Pin is captured in
the Groove in the top of the Hanger Ball (Figure 10) .
Pull the Hanger Ball up tight against the Pin and
securely tighten the Set Screw in the Hanger Ball.
NOTE: A loose set screw could create fan wobble.
It is critical that the pin in the hanger ball is properly
installed and the set screw securely tightened. Failure
to verify that the pin and set screw are properly
installed could result in the fan falling.
WARNING
!
BLACK WIRE
6 TO 9
INCHES
WHITE WIRE
HANGER BALL
1/2
INCH
3.11
The Fan comes with Black and White Wires that are
80” long.
Measure up approximately 6 to 9-inches above top of
Hanger Ball / 6” Downrod Assembly (Figure 11).
Cut off excess Leads and strip back insulation 1/2-inch
from end of Wires, using Wires Strippers.
Figure 11
Summary of Contents for CF765BQ01
Page 22: ...22 U L Model No CF765 1 Notes ...
Page 46: ...46 No de modelo U L CF765 1 Notas ...