Emerson BRADDOCK CF440VNB, Owner'S Manual, Page: 9 / 16

9 U.L. Model No.: CF440
1.
With the fan assembly safely installed on the
mounting bracket, remove and retain the wire
connectors from the white and blue wires located
on the bottom of the motor (Figure 15).
2.
Connect the white wire from the ceiling fan to the
white wire of the light kit assembly (Figure 15).
Connect the blue wire from the ceiling fan to the
black wire of the light kit assembly. Use wire
connectors (previously removed) to make
connections.
3. Remove one of the one of the three screws from
the light kit adapter plate and loosen the remaining
two screws (Figure 15).
NOTE: Make sure all wires and connector are
tucked under the light kit assembly and not
pinched between light kit assembly and light kit
adapter.
4.
Position the light kit assembly under the light kit
adapter plate, align the two key slots on the light
kit with the two screw heads loosened earlier.
Rotate the light kit assembly to engage the two
screws into both slots and tighten both screws
(Figure 16). Securely re-install the screw,
previously removed, into the remaining hole of the
light kit assembly.
5. Screw in two 60-watt (maximum) candelabra base
bulbs into the downlight assembly sockets
(Figure 16).
6. Remove the finial nut, hex nut and rubber washer
from the light kit's threaded nipple. Retain for
reinstallation.
7.
Place the lower glass onto the threaded nipple and
seat the glass onto the light kit assembly
(Figure 17). While holding the glass in position,
tightly re-install the rubber washer and hex nut.
Securely re-install the finial nut onto the threaded
nipple.
NOTE: Periodically check that the glass bowl is
seated correctly onto the light kit assembly and
the hex nut and finial nut are tightly fastened.
8. Installation of your ceiling fan is now complete.
Restore electrical power to the branch circuit at the
fuse box or breaker panel.
Lower Light Kit Assembly
CEILING FAN
WHITE WIRE
LIGHT KIT ASSEMBLY
WHITE WIRE
LIGHT KIT
ASSEMBLY
BLACK WIRE
CEILING FAN
BLUE WIRE
LIGHT KIT
ASSEMBLY
MOUNTING
BRACKET
REMOVE ONE
LIGHT KIT
ADAPTER PLATE
SCREW
Figure 15
LIGHT KIT
ASSEMBLY
LIGHT
SOCKET (2)
60-WATT (max.)
CANDELABRA BASE
BULB (2)
LIGHT KIT
ASSEMBLY
SCREW (3)
Figure 16
LOWER GLASS
SHADE
LIGHT KIT
ASSEMBLY
RUBBER WASHER
HEX NUT
FINIAL NUT
Figure 17
Please call Emerson technical support at
1-800-654-3545 if you have any questions
about installation and operation of this ceiling fan.