3
Unpacking Instructions
1.
Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor assembly
b. One ceiling cover
c. One coupling cover
d. One upper decorative assembly
e. One upper glass
f. One light kit retention ring
g. Five fan blades
h. Five fan blade flanges
i. One light kit assembly including one finial nut
j. One lower glass
k. One hanger bracket
l. One hanger ball/4.5” downrod assembly
m.One receiver and 4-speed hand control
n. Four 15-watt (maximum) candelabra base uplight
bulbs
o. Two 60-watt (maximum) candelabra base
downlight bulbs
p. One loose parts bag containing:
1. One clevis pin
2. One hairpin clip
3. Three 12 ga. wire connectors
4. Two #8-32 x 1-1/4” threaded studs
5. Two #8 external tooth lockwashers
6. Two #8-32 knurled knobs
7. Sixteen #10-24 x .50” washer head
blade screws
8. Sixteen #10 x .63 flat washers
9. One spare 1/4-20 x .56” captive screw
with lockwasher
10. One spare #8-32 x .31” pan head screw
11. One balancing kit
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal
injury or property damage.
A. FAN MOTOR
ASSEMBLY
B. CEILING
COVER
C. COUPLING
COVER
D. UPPER DECORATIVE
ASSEMBLY
E. UPPER GLASS
G. FAN BLADES
H. FAN BLADES
FLANGES
F. LIGHT
KIT RING
K. HANGER
BRACKET
J. LOWER
GLASS
I.
LIGHT KIT
ASSEMBLY
L. HANGER BALL/
4.5" DOWNROD
ASSEMBLY
M. FAN/LIGHT
REMOTE CONTROL
P. LOOSE
PARTS BAG
N. 15-WATT
BULBS (4)
O. 60-WATT
BULBS (2)
WARNING
!
WARNING
!
NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.
2.
Remove and discard the two cardboard shipping
pads securing the motor hub in the motor housing
assembly.
NOTE: Failure to remove the cardboard pads will
result in noisy fan operation.
3.
Remove the lower styrofoam pad from the carton
and place on a stable work surface.
4.
Remove the fan motor assembly from the
protective plastic bag and set on top of the lower
styrofoam padding. Place all carton contents on a
soft protective surface.
U.L. Model No.: CF440