November 2015
Installation, Operation and Maintenance Manual
RGS011110-1 Rev. 0
17
Section 4: Maintenance
Maintenance
Reassembly:
9.
Lubricate and install O-ring(s), saddle pin(s), saddle pin thrust washers and roller(s).
10.
Lightly coat all O-rings and bushings with lubricant.
11.
Install O-rings on internal and external surfaces of bushing(s) in respective
O-ring grooves.
Figure 17
12.
Insert one bushing into bottom side of shaft hole (side which contains shoulder
to prevent bushing from falling out). The bushing should be placed with external
O-ring closer to the center of the body of the actuator.
Figure 18
