Figure 3-1: Spot face or end mill tool
Attachment tools and supplies
•
40-200 inch-lb torque wrench with 1/8 in. hex bit
Suggested vendor: Grainger (P/N 4YA74)
Description: 3/8" drive inch-lb torque wrench. You can substitute with any torque
wrench with a range of 40 to 70 inch-lb and less than 5 inch-lb increments.
•
1/4-28" taps and tap handle
•
9/16" open-end wrench
•
1/8" hex Allen key
•
Wire brush
•
Plant-approved cleaner/degreaser
•
Plant-approved semi-permanent thread locker (e.g. Loctite)
For epoxy mount, you also need the following:
•
2-part epoxy
•
A212 Mounting Pads
Figure 3-2: A212 mounting pad
•
(Optional) Grinder – to create a sufficiently flat mounting surface
For motor fin mount, you also need the following:
•
Motor Fin Mount Probe
•
Epoxy
3.3
Mounting mechanisms
The device may be mounted using any of these mounting mechanisms:
Installation
User Guide
July 2020
MHM-97927-PBF
40
MHM-97927-PBF, DRAFT
Summary of Contents for AMS
