Emerson 2130 RBM Consultant Pro, Reference Manual

Page: 296 / 394

4-10 Vertical Alignment
Print Job
The Print Job key prints a summary report of the current job to the Virtual Printer,
if the Virtual Printer is enabled under the General Setup screen of the System Firm-
ware. A summary report includes job information, notes, soft foot data, and
reading set data (machine feet moves and Angle/Offset data). The report includes
only the first and last reading sets that were acquired. The summary report will be
similar to the report displayed on page 3-10.
Job Reset
Clear Job Data
Use the Clear Job Data function to clear all stored data and notes from the active
job. Before any data is cleared, a warning message will be displayed asking the oper-
ator if this is truly the operation to be performed. If the operator answers yes, then
the data stored on the job will be cleared and the operator is taken back to the Main
screen. If the operator answers no, then the operation is aborted and you will
return to the Alt Main screen.
Load Default Values
Use the Load Default Values function to load job default parameters. Before any
defaults are loaded, a warning message will be displayed asking the operator if this
is truly the operation to be performed. If the operator answers yes, then the job
defaults are loaded and all job data is cleared and the operator remains at the Alt
Main screen. If the operator answers no, then the operation is aborted and the
operator remains at the Alt Main screen.
Load Default Tolerances
Use the Load Default Tolerances function to load default alignment tolerances.
Before any defaults are loaded, a warning message will be displayed asking the
operator if this is truly the operation to be performed. If the operator answers yes,
then the default alignment tolerances are loaded and the operator remains at the
Alt Main screen. If the operator answers no, then the operation is aborted and the
operator remains at the Alt Main screen.