Emerson 2130 RBM Consultant Pro, Reference Manual

Page: 246 / 394

3-166 Horizontal Alignment
Data Detail (Tolerance Plot) Function Keys
Display Sine Fit
Use the Display Sine Fit key to advance to the sine fit data plot where you can review
and manually condition or edit the sine curve data. This key is only active if the data
was acquired using the Auto Sweep, Dual Pass, or Manual Sweep methods. Refer to
the Display Sine Fit section on page 3-168 for more information.
View Data
Use the View Data key to advance to the View Data screen where you can review the
alignment data in the traditional cardinal positions (0°, 90°, 180°, and 270°). Refer
to the View Data section on page 3-174 for more information.
Full Screen
Use the Full Screen key to display the plot in “full” screen mode. In full screen
mode, the soft keys disappear and only function to return the display back to its
original size.
Switch Plot Type
Use the Switch Plot Type key to toggle the plot type between the Four Quadrant
Tolerance plot, Dual Tolerance plot, Single Vertical Tolerance plot, and Single
Horizontal Tolerance plot.
Show All
Use the Show All key to display all readings acquired. This key is only active when
more than three readings are stored on the job and only the last three readings
acquired are displayed.
Show Last 3
Use the Show Last 3 key to display only the last three readings acquired. This key is
only active when more than three readings are stored on the job and all readings
acquired are displayed.
Expand X Axis
Use the Expand X Axis key to expand the X Axis by a factor of two.
Compress X Axis
Use the Compress X Axis key to compress (contract) the X Axis by a factor of two.