Figure 12 Installing the stabilizer screws
CL5008
Connecting cables
Procedure
1. Plug the power cords into the power supplies and connect these cords to AC power
sources as described in the documentation for your product.
2. Attach any I/O cables as described in the documentation for your product.
Installing the bezel
Bezels are application specific, and may not appear as shown. Bezels may include a key
lock. All bezels include two tabs on either side that you press in to release the bezel and
its latches.
Refer to
while you perform the procedure that follows.
Procedure
1. Pushing on the ends, not the middle, of the bezel, press the bezel onto the latch
brackets until is snaps into place.
2. If the bezel has a key lock, lock the bezel with the provided key and store the key in a
secure place.
Connecting cables
13
