EMC Connectrix ED-64M, User Manual

Page: 380 / 476

E
E-46
Connectrix ED-64M User Guide
Command Line Interface
Parameters This command has one parameter.
Command Example
Root> config switch priority principal
config.switch.raTOV
Syntax
raTOV timeoutValue
Purpose This command sets the R_A_TOV for the director.
Description The director must be off line before issuing this command. Use
maint.system.setOnlineState
to set the director off line.
Special care should be used when scripting this command due to its
relationship with E_D_TOV.
switchPriority
Specifies the switch priority. Valid values are:
principal
, default, or neverprincipal:
◆
principal sets the numerical switch priority
to 1. The switch/director with a priority of 1
becomes the principal switch; however, if
two or more switches/directors have a
priority of 1, the switch/director with the
lowest WWN becomes the principal switch.
◆
default sets the numerical switch priority
to 254. If no switch/director is set to
principal, the switch/director with a
priority 254 becomes the principal switch;
however, if two or more switches/directors
have a priority of 254, the switch/director
with the lowest WWN becomes the
principal switch
◆
neverprincipal sets the numerical switch
priority to 255. This switch/director is not
able to become the principal switch.
At least one switch/director in a multiswitch fabric
must have a switch priority value of principal or
default
.