EMC Connectrix ED-64M, User Manual

Page: 314 / 476

A
A-98
Connectrix ED-64M User Guide
Using SNMP to Manage the Switch
Threshold Alert Table
Table A-49 Threshold Alert Table
FCEOS MIB Object Name Type Provided by Access Description
fcEosTAIndex INTEGER PCP R This object is used to identify which threshold has been
triggered.
fcEosTAName DisplayString
(SIZE (1..64)) PCP R The threshold alert name.
fcEosTAState INTEGER PCP R The current state of the threshold. (enabled = 1,
disabled = 2)
fcEosTAType INTEGER PCP R The type of the threshold. (throughput = 1, counter = 2)
fcEosTAPortType INTEGER PCP R A threshold can be set on a list of physical port numbers
or on all the ports of the specified type (ePorts, fPorts).
(list = 1, ePorts = 2, fPorts = 3, flPorts = 4)
fcEosTAPortList fcEosPortList PCP R A bit map that identifies which ports this threshold alert
applies to (only valid if the Threshold Alert Port Type =
list). The left most bit represents the port 0.
fcEosTAInterval INTEGER PCP R The number of minutes in a threshold alert interval.
fcEosTATriggerValue INTEGER PCP R If the alert type is a Throughput Threshold Alert, then
this is the percent utilization (1-100) required to trigger
an alert. If the alert type is a Counter Threshold Alert,
then this is the counter delta required to trigger an alert.
fcEosTTADirection INTEGER PCP R This only applies when the alert type is a Throughput
Threshold Alert. It specifies the throughput direction of
the threshold. (Transmit = 1, receive = 2, either = 3)
fcEosTTATriggerDuration INTEGER PCP R This only applies when the alert type is a Throughput
Threshold Alert. It specifies the amount of time during a
threshold alert interval that the trigger must be
exceeded before an alert is generated.
fcEosCTACounter INTEGER PCP R This only applies when the alert type is a Counter
Threshold Alert. It specifies statistical counter or
counter set to be monitored. (This object is not
supported in the current release.)