2
Configuring EMC ControlCenter
2-23
Connectrix Manager Administration
Configuring EMC ControlCenter
EMC ControlCenter is a separately purchased product available for
managing the enterprise storage network. To establish
communications between the Connectrix Manager and the EMC
ControlCenter, follow these steps:
1. Move your mouse cursor over the Configure icon in the
Connectrix Manager’s navigation control panel, then click SNMP
on the pop-up menu.
Figure 2-10
Configure SNMP Dialog Box
2. Make sure the Enable SNMP Agent check box is checked. If it is
not, click it to add a checkmark.
3. Obtain the IP address of the EMC ControlCenter server and the
SNMP Community Name used by the ControlCenter server, and
enter this information into the dialog box for the Trap Recipient.
4. To specify a UDP port number, click Advanced, then enter the
number.
5. Click Activate for the changes to take effect.
Summary of Contents for Connectrix EC-1100 System
