EMC PARTNER AG
141/162
12.5 Software "GENECS" for TRA3000 F-S-D-V-C Remote Control
The GENECS software delivered on a CD (the CD can be found in the cover of the calibration report
binder), can be used to control the TRA3000 F-S-D-V-C via the Ethernet port.
12.5.1 Setup GENECS
See instruction on the CD. Follow the instruction of the installer program. When the GENECS is installed
and the TRA3000 F-S-D-V-C connected via the Ethernet cable (Art Nr. 104537, patch cord cat. 5e FTP
type crossover to CTRL3000, red, 3m), the display of the TRA3000 F-S-D-V-C and the display of the
GENECS must show the same figure.
12.5.2 GENECS Windows
The GENECS windows is identical to the TRA3000 F-S-D-V-C front plate. Online the TRA3000 F-S-D-V-C
can be remote controlled by pressing the buttons with the mouse cursor as on the real front plate.
Detailed information can be obtained from the "help index" or the specific User Manual of the
GENECS-TRA Software.
Summary of Contents for EXTTRA3000 E
