EMBRON Hatteland HT20 70 Series, User Manual

Page: 57 / 154

57
IND100129-206
All specifications are subject to change without prior notice!
Specifications - Isolated COM Module RS-232
PCA100309-1
1/2
This information may not, in whole or in part, be copied, photocopied,
reproduced, translated or reduced to any electronic medium or machine-
readable form without the prior written consent of Hatteland Technology
AS. The products may not be copied or duplicated in any way.
Dimensions might be shown with or without decimals and indicated as mm [inches]. Tolerance on drawings is +/- 1mm. For accurate measurements, check relevant DWG fi le.
DATASHEET
Hatteland Technology AS | www.hattelandtechnology.com | Enterprise no: NO974533146
Note: Product below for illustration only. Location of module and product size/design may differ. Connector/pinning remain the same.
*Configuration dependent, x = next available port number(s) in operating system.
Illustration and Pinning:
2 channel COM RS-232, DB9M COM Module
Manufacturer: Hatteland Technology AS
Product: COM Module RS-232
Typenumber: PCA100309-1
Last Revised: 27 Apr 2022
Revision#: 07
Features:
The Hatteland Technology COM module provide the system with dual independent COM channels. The module is attached to the
motherboard via standard USB interface. Application software access the COM channels as standard COM devices, i.e. in the normal
case is there no requirements for additional software development. This module will mainly be integrated, electrical and mechanical, in
the final product such as Series X G1/G2 Panel Computers and selected stand-alone computers.
Description:
Internal USB to 2 channel x RS-232 isolated
• Features Both channels have support for all RS-232 DB-9 signals
• Connector Standard RS-232 DB-9 male housing and pinning
• Data Rate Tested from 300 up to 115200 Baud Rates
• ESD Rating (IEC 1000-4-2 Air)
(RS-232 I/Os)
±15 kV
• ESD Rating (IEC 1000-4-2 Contact)
(RS-232 I/Os)
±8 kV
• Test and certificate Hatteland Technology standard,
(tested / type approved by the following classification societies):
IEC 60945 4th (EN 60945:2002), IACS E10 , EU RO MR - Mutual Recognition,
ClassNK - Nippon Kaiji Kyokai
• Supported Operating Systems (OS) Embedded Enterprise (WEE): Microsoft® Windows® Server 2003/2008/2008R2 (Eng),
Microsoft® Windows® 2003/2008/2008R2 (Eng), Microsoft® Windows® 7 Professional/
Ultimate (Eng, SP1), Windows® 10 IoT Enterprise 2016 LTSB.
Linux: Kernel 3.0.0-64 or above
• Drivers/Documentation https://www.hattelandtechnology.com/drivers?key=19.8.13.57.X.X.X
Note: Listed Operating Systems above are hardware/platform dependent. Please check datasheet for specific unit if OS is supported.
- 2 independent channels (If a card is replaced most operating system will not change COM port number)
- Outputs are short circuits protected
1 2 3 4 5
6 7 8 9
2 Ports available in Operating System as:
COMx (A)*, COMx (B)*
Pinout Assignments
67
IND100241-13
Appendix
Analog RGB/VGA, 15-pin DSUB High Density Female
1 2 3 A B
5 4 3 2 1
15 14 13 12 11
10 9 8 7 6
PIN 01 RED Red, analog
PIN 02 GREEN Green, analog
PIN 03 BLUE Blue, analog
PIN 04 ID2/RES Reserved for monitor ID bit 2 (grounded)
PIN 05 GND Digital ground
PIN 06 RED_RTN Analog ground red
PIN 07 GREEN_RTN Analog ground green
PIN 08 BLUE_RTN Analog ground blue
PIN 09 KEY/PWR +5V power supply for DDC (optional)
PIN 10 GND Digital ground
PIN 11 ID0/RES Reserved for monitor ID bit 0 (grounded)
PIN 12 ID1/SDA DDC serial data
PIN 13 HSYNC. Horizontal sync or composite sync, input
PIN 14 VSYNC. Vertical sync, input
PIN 15 ID3/SCL DDC serial clock
Serial COM RS-232 non-isolated, 9-pin DSUB Female
1 2 B
5 4 3 2 1
9 8 7 6
PIN 01 BUZ+ Buzzer Control Positive*
PIN 02 TxD Transmit Data
PIN 03 RxD Receive Data
PIN 04 DTR Data Terminal Ready
PIN 05 GND Ground
PIN 06 DSR Data Set Ready
PIN 07 RTS Request To Send
PIN 08 CTS Clear To Send
PIN 09 BUZ- Buzzer Control Negative*
*Wake On Ring is not enabled
Serial COM RS-485/RS-422, 9-pin DSUB Male
“Full Duplex Mode*
3 B
1 2 3 4 5
6 7 8 9
PIN 01 TxD- Transmit Data Negative
PIN 02 TxD+ Transmit Data Positive
PIN 03 RxD+ Receive Data Positive
PIN 04 RxD- Receive Data Negative
PIN 05 GND Signal Ground
PIN 06 N/C No internal connection
PIN 07 N/C No internal connection
PIN 08 N/C No internal connection
PIN 09 N/C No internal connection
*Master only. ECHO not supported.
Serial COM RS-485/RS-422, 9-pin DSUB Male
“Half Duplex Mode*
3 B
1 2 3 4 5
6 7 8 9
PIN 01 Res. Reserved, do not connect
PIN 02 Res. Reserved, do not connect
PIN 03 Data+ Data Positive
PIN 04 Data- Data Negative
PIN 05 GND Signal Ground
PIN 06 N/C No internal connection
PIN 07 N/C No internal connection
PIN 08 N/C No internal connection
PIN 09 N/C No internal connection
*ECHO not supported.
Half Duplex Confi guration: Via Hatteland Display API.
Flow control: Via RTS signal (controlled by user application).
Serial COM RS-232 non-isolated, 9-pin DSUB Male
3 B
1 2 3 4 5
6 7 8 9
PIN 01 DCD Data Carrier Detect
PIN 02 RxD Receive Data
PIN 03 TxD Transmit Data
PIN 04 DTR Data Terminal Ready
PIN 05 GND Signal Ground
PIN 06 DSR Data Set Ready
PIN 07 RTS Request To Send
PIN 08 CTS Clear To Send
PIN 09 RI Ring Indicator
COM Module RS-232 - 4 x ports, 9-pin DSUB Male
Type Number “PCA100294-1”
3 A B
B
A
D
C
1 2 3 4 5
6 7 8 9
PIN 01 DCD Data Carrier Detect
PIN 02 RxD Receive Data
PIN 03 TxD Transmit Data
PIN 04 DTR Data Terminal Ready
PIN 05 GND Signal Ground
PIN 06 DSR Data Set Ready
PIN 07 RTS Request To Send
PIN 08 CTS Clear To Send
PIN 09 RI Ring Indicator
A B