iMX RT1176 uCOM Developer’s Kit - User’s Guide
Page 13
Copyright 2021 © Embedded Artists AB
3
uCOM Carrier Board Design
This chapter contains information about the peripherals and general design of the
uCOM Carrier Board
and how to set the different jumpers on the board. The schematic can be downloaded in pdf format
from the support page, and is recommended to have printed out while reading this chapter.
Section naming begins with
SPx
, which is short for
Schematic Page x
.
The picture below gives an overview of the
uCOM Carrier Board
design.
Figure 9 – uCOM Carrier Board, rev A, Overview
3.1
Modifications to uCOM Carrier Board
The
uCOM Carrier Board
has been designed to be flexible. Most options can be controlled via jumpers
but some options might need soldering.
Note that modifications to the board are done at own risk and void all warranties.
uCOM Board
Connectors
Ethernet
Interface
ISP Enable, onoff, reset,
wakeup and user push-buttons
Power Supply
Input
Expansion
Connectors
Debug
Connectors
uSD
Interface
USB Host
Interface
USB OTG
Interface
UART-to-USB
Interface
M.2 E-key
Connector
MIPI-CSI
Interface
MIPI-DSI
Interface
M.2 B-key
Connector
Mikrobus
Connector
Parallel RGB
display Interface