EMB Wallenstein CR Series, Operator'S Manual, Page: 28 / 69

28
4.8 ROLLER FEED CONTROL BAR:
The feed roller control bar controls the forward, reverse and stop action of the feed rollers.
IMPORTANT
To quickly stop the feed rollers
in an emergency situation, the bar can
be rapidly pulled or pushed to its maxi-
mum position and will lock in the stop
position till it is released by the detent
reset handle.
1. Pull the bar to its maximum detent position
away from the feed table, locks it into a stop
position, and feed rollers stop turning.
To unlock the bar from the stop posi-
tion: raise the detent reset handle
and pull the bar out of detent.
2. Push the bar to the next detent position and
the feed rollers begin to turn forward (feed).
This is the normal operating position for
the control bar and will stay in position until
moved.
3. Push the bar to its next position and the feed
rollers will reverse. When the control bar is
released it will automatically return to the
forward (feed) position. The control bar can
be moved freely between forward and reverse
without locking.
4. Push the bar to its maximum detent position,
towards the feed table, locks it into a stop
position, and feed rollers stop turning.
To unlock the bar from the stop posi-
tion: raise the detent reset handle
and pull the bar out of detent.
Stop (locked)
Forward (Feed)
Reverse
Stop (locked)
Detent Reset
Handle
Feed Roller
Control Bar
Note: Left side view is shown,
both left & right side are labeled.