IMPORTANT: The instruction manual you are holding includes essential
information on the safety measures to be implemented for installation
and start-up of this appliance. Therefore, the installer as well as the user
must read the instructions before beginning installation and start-up.
Keep this manual for future reference.
P2
This device is intended for swimming pools and spas only; do not use it
for potable water sanitation (drinking water).
This electricity supply must be connected through a residual current
device (RCD) or Ground Fault Circuit Interrupter (GFCI) with a rated
residual operating current not exceeding 30 mA, otherwise could result
in electrical shock causing serious bodily injuries, including death.
1. IMPORTANT SAFETY INSTRUCTION
1.1
Use and safety tips
Make sure that the installation of the device complies with electrical safety regulations. This
instrument should be installed, used or maintained under the guidance of professional
technicians.
The operator must aware of the possible consequences caused by parameter changes before
using.
1.1.1
Electric safety
The controller must be connected to power source which matched to rate power and voltage.
In order to ensure that all safety requirements are met, the controller must be used with the
accessories specified in this manual, because those accessories has been tested their
compatibility with the controller. If damaged or malfunctioning is found, it must be repaired
or replaced by an authorized technical service center immediately.
1.1.2
Operating safety
Water drop and moisture must be prevented from entering the controller, or immerse the
controller in liquid. If liquid enters the controller accidentally, turn the power off immediately.
Clean the control and then hand it over to the relevant technicians for overhaul.
Notice:
•
The controller should be operated pair with accessories which noted in this manual, and the
controller must operate in full compliance with safety requirements.
• The controller must be used within operating condition which noted in this specification.
The parameter settings of the controller must match with the water quality standards
requirement for the region.
• The controller must be located in a place where pool operator or technician can monitor the
alarm signals of the controller easily.
• To avoid any dangerous situation, pool owner/ operator/ technician must strictly follow the
instructions.
• Process with caution and monitor pool water conditions are in safety range.
• If the controller is not operated in accordance with the above notice, our company will not
be liable for any property or personal injury that may be caused thereby.
