EN
6
Use of the BioProTT
TM
Clamp-On SL
6.1
General Safety Information
•
Inspect your BioProTT
TM
Clamp-On SL for completeness and damage when unpacking it for the
first time.
•
If the BioProTT
TM
Clamp-On SL is not used as intended, the user may be exposed to risks
that were not taken into account during its development.
•
If the BioProTT
TM
FlowMeasurement System is used to control the liquid volume flow, the
user must analyze the risk of the application and, if necessary, take actions independent of
the BioProTT
TM
FlowMeasurement System to minimize the risk.
•
For the installation, and later the operation, all ambient conditions must meet the
prescribed specifications (see
chapter 10 “Technical Specifications”
•
The user (= the person who connects the BioProTT
TM
Clamp-On SL to the
tubing circuit and measurement system) is responsible for any risk if the
BioProTT
TM
Clamp-On SL is not connected correctly.
•
Do not drop the BioProTT
TM
Clamp-On SL. It might break or get damaged, which could impair
the measurement.
6.2 Connecting the BioProTT
TM
Clamp-On SL to the Evaluation Device
Lab Applications using the BioProTT
TM
FlowTrack SL
To connect the BioProTT
TM
Clamp-On SL to the BioProTT
TM
FlowTrack SL, follow the steps listed below: :
•
Carefully attach the round sensor plug to the sensor connection of the evalution device.
For the BioProTT
TM
FlowTrack SL, this is located at the back of the device.
•
If it is possible and necessary to use an extension cable, connect the sensor to one end of the extension
cable and the other end of the extension cable to the evaluation device.
•
Once this is done, the sensor can be attached to the tube.
Industrial Applications using a device of the BioProTT
TM
FlowMCP Series:
To connect the BioProTT
TM
Clamp-On SL to one of the evaluation devices of the BioProTT
TM
FlowMCP Series,
follow the steps listed below:
•
Carefully attach the extension cable to the respective BioProTT
TM
FlowMCP (D-Sub).
For the BioProTT
TM
FlowMCP Series, this is located at the bottom of the respective device
•
Connect the sensor to other end of the extension cable (round plug).
•
Once this is done, the sensor can be attached to the tube.
Please note:
The total cable length between the respective evaluation device and the
BioProTT
TM
Clamp-On SL shall not exceed 4 m.
BioProTT™ Clamp-On SL
Page 10
Copyright em-tec GmbH
D162-704 BioProTT™ Clamp-On SL – User Manual– V4.0
DocuSign Envelope ID: BE88571C-E493-4DFB-AF9A-864EB3FC3D75
