elvita CBD6602V, Quick Start Manual

Page: 13 / 76

Before first use - ENGLISH 13
© 2021, Elon Group AB. All rights reserved.
BEFORE FIRST USE
CAUTION!
Before washing, make sure the dishwasher is correctly installed.
Adjust the water softener level
Set the water softener level according to the hardness of the water in your area. See the following table to select the
appropriate level. Your local water authority can advise you on the local water hardness.
Water hardness Water softener
level Regeneration
occurrence* Salt
consumption
(grams/cycle)
German °dH French °fH British °Clarke mmol/l
0 - 5 0 - 9 0 - 6 0 - 0.94
H1 - is
displayed
No
regeneration 0
6 - 11 10 - 20 7 - 14 1.0 - 2.0
H2 - is
displayed
10 9
12 - 17 21 - 30 15 - 21 2.1 - 3.0
H3 - and
are displayed
5 12
18 - 22 31 - 40 22 - 28 3.1 - 4.0
H4 - is
displayed
3 20
23 - 34 41 - 60 29 - 42 4.1 - 6.0
H5 - and
are displayed
2 30
35 - 55 61 - 98 43 - 69 6.1 - 9.8
H6 - and
are displayed
1 60
*Regeneration occurs every X programme sequence.
NOTE!
Every cycle with a regeneration operation increases the water consumption by 2.0 litres of water, the energy
consumption by 0.02 kWh, and the programme duration by 4 minutes.
1. Close the door.
2.
Press to turn on the machine.
3.
Within 60 seconds, press and hold for more than 5 seconds to enter the water softener setup mode.
4.
Press to cycle through the available water softener levels ( H1 , H2 , H3 , H4 (default), H5 , H6 ).
5.
Press to confirm and to exit the water softener setup mode.
You will exit the water softener setup mode if you leave the settings unchanged for 5 seconds.
Add salt to the water softener
Do this when is displayed.