WB-15-W. User manual
30
•
•
•
•
•
•
•
•
•
•
•
•
•
•
The list of objects which are supported for reading and configuration via SNMP is given below:
Enterprise.2.1 – SNMP settings
Enterprise.3.1 – syslog settings
where Enterprise – 1.3.6.1.4.1.35265.1.56 is ELTEX identifier
To apply a new configuration and store settings into the non-volatile memory, click the «Apply» button. Press
«Cancel» to discard the changes.
4.8 The «Radio» menu
In the «Radio» menu you can configure the wireless interface
4.8.1 The «Radio» submenu
In the «Radio» submenu, you can configure the device’s radio interface.
Mode
– select interface operation mode:
IEEE 802.11b;
IEEE 802.11g;
IEEE 802.11n;
IEEE 802.11b/g;
IEEE 802.11b/g/n;
Channel Bandwidth, MHz
– bandwidth of the channel on which the radio interface of the device operates,
takes values 20, 40;
Primary Channel –
primary channel of the radio interface. The setting is available when you select a
bandwidth of 40 MHz - in this case, the total channel of 40 MHz is formed from two adjacent frequency
channels of 20 MHz. The choice of the main channel is determined by the position relative to the additional:
Upper - the frequency of the main channel is higher than the frequency of the additional;
Lower - the frequency of the main channel is lower than the frequency of the additional;
Channel
– select channel for data transmission;
Transmission Power Limit, dBm
– transmitting Wi-Fi signal power adjustment, dBm.
