Elster Instromet EK205, Operating Manual, Page: 37 / 71

Installation , connection and commissioning 37
5.3.2.3 Sensors
The sealing of the connected temperature and pressure sensors is illustrated in
chapters 5.2.3 and 5.2.4 as an example.
5.3.3 Close housing
CAUTION!
Damage to property caused by improper device closure!
If the device is not properly closed cables can get pinched and cause damage.
Therefore:
– Ensure correct positioning of the cable guide when closing.
5.3.4 Check installation and connection
WARNING!
Risk from improper installation and connection!
Improper installation and connection of the EK205 may result in fatal situations.
Therefore:
–
Carry out the installation and connection of the EK205 correctly.
– Observe the requirements of the standards and guidelines stated in the
design test certificates.
5.3.5 Data transfer
For the various options of remote data transmission to a control room via a device connected
to the terminal interface, please observe the corresponding instructions in the application
manual EK205, which you can download from www.elster-instromet.com/en (-> documents).
The settings of the data transfer are possible without opening the calibration lock.
Ill.: 17
1. Close the housing using the four pre-installed
screws (Ill. 17/1).
2. Do not close the cable screw connections used with
matching sealing plugs.
1