38
Parameter setting
Sensor Vari KNX 3L-TH-D
• Status: 19.10.2016 • Errors excepted. Subject to technical changes.
The behaviour of the switching output on release is dependent on the value of the pa-
rameter "Switching output sends" (see "Switching output")
6.4.
Brightness measurement value
Sensor 1-3
Give the brightness sensors 1-3 a nomenclature and set the transmission behaviour for
the measurement values.
Total measurement
Select the type of the total measurement and set the transmission behaviour for the
total measurement.
On release
(with 2 seconds release delay)
[Dependent on the "Switching output
sends" setting]
Switching output sends on change
• Do not send message
• Send switching output status
Switching output sends on change to 1
• Do not send message
• if switching output = 1
send 1
Switching output sends on change to 0
• Do not send message
• if switching output = 0
send 0
Switching output sends on change and
periodically
Send switching output status
Switching output sends on change to 1
and periodically
if switching output = 1
send 1
Switching output sends on change to 0
and periodically
if switching output = 0
send 0
Sensor nomenclature
S1 [Free text]
Send pattern
• never
• periodically
• on change
• on change and periodically
at and above change in %
(if sent on change)
1 ... 100; 20
Send cycle
(if sent periodically)
5 s ... 2 h
Type of total measured value
• Mixed value from all 3 sensors
• Maximum value of the 3 sensors
Sensor 1-3 share in %
(if total measured value is a mixed value)
0...100; 33
Summary of Contents for Vari KNX 3L-TH-D
Page 5: ...4 Clarification of signs ...
