67
System settings via touch display
Display Corlo Touch KNX
• Status: 09.03.2017 • Technical changes and errors reserved.
Then use the
Next
key (bottom right) to skip to the next setting.
Confirm with
OK
to save and return to the previous menu selection.
Or cancel using the
skip back arrow
or the
house button
.
3.9.
Alarm
The
Display Corlo Touch KNX
may trigger a wake-up call with a sound alarm and
flashing display at a pre-set time. At the same time, the display shows the time and a
button to switch the alarm off.
If the alarm is not switched off manually, it stops by itself after the set alarm time is
reached. Alternatively, the wake-up call can be switched off via the bus. After the
Select the period you wish to modify.
Only the periods preconfigured in the ETS
are displayed.
In the example, period 15 and 16 have been
configured as inputs in the ETS. The timer
information arrives via the bus, no
modification may be applied.
Set the start and end of the period
respectively. In order to do this, activate the
field for the hour and then for the minutes
and sue the +/- buttons on the rocker to
adjust the desired time.
Select the day of the week on which the time
period should be activated.
In the example, the period lasts from 07:00
to 09:30 and is active Sunday through
Summary of Contents for Corlo Touch KNX 70258
Page 2: ......
