18
Description
Display Corlo Touch KNX
• Status: 09.03.2017 • Technical changes and errors reserved.
Ventilation device
In order to control ventilation devices, the ambient parameters/measuring values
•
Outdoor temperature
•
Indoor temperature
•
Indoor air humidity
•
CO2 content of indoor air
•
Time
are needed.
•
Rotational speed can be adjusted
•
Ventilation based on indoor temperature, air humidity and room air CO2
content
•
Outdoor temperature block: Block when below a selected outdoor temperature
•
No ventilation when the supply air temperature is higher than the room
temperature
•
Timed ventilation
•
Night-time re-cooling (period, room temperature and ventilator rotational
speed can be set)
•
Automatic resets (time/periods can be set)
Heating and cooling
For the control of heating/cooling, the ambient parameter/measuring value
•
Indoor temperature
is needed.
•
Heating and cooling can be set in two degrees, 1. Level PI control, 2. Level PI
control
or 2-point control
•
The values for the comfort, standby, eco and frost protection modes can be set
separately, or the comfort value is used as the starting point.
•
Switch between heating and cooling by means of a dead zone or by means of
a switching object
•
Day extension (eco mode may be temporarily deactivated)
•
Frost protection (reference value and activation delay can be set)
•
Heat protection (reference value and activation delay can be set)
1.7.2. Overview of functions
May be set/modified
via ETS
on the display
Screen (brightness, screen saver...)
Yes
Yes
Ambient lighting
Yes
Yes
Logo lighting (only for engraved logos)
Yes
Yes
Button tone
Yes
Yes
Proximity sensor
Yes
–
Alarm
Yes
Yes
Summary of Contents for Corlo Touch KNX 70258
Page 2: ......
