86
Basic settings in the Control Center
CasaConnect KNX Control Center
• Version: 13.09.2021 • Technical changes and errors excepted.
Symbol:
Shows the selected symbol for the subgroup. Touch the field and select a symbol from
the lists.
Assign channels:
Touch the field and select the functions to be added to the group. Only the functions
that go with the subject are displayed for each group.
Display sequence:
Touch the field to specify the display sequence of the selected channels. All entries are
shown in a list. Hold an entry by the list symbol on the right and move it to the desired
position.
5.2.6. Weather display
The current data received by the bus is displayed on the start page. The displayed tem-
perature of the weather station can be adjusted. If multiple temperature sensors are in-
stalled, select the sensor here, the data from which should be displayed on the start
page.
System > Set screen > Weather data
Outdoor temperature:
Touch the field to set the sensor for the outdoor temperature. If the weather station is
selected, you can adjust the displayed temperature value here. This adjusted value is
also used for the control center!
Indoor temperature:
Shows which sensor is used for the indoor temperature display on the start page. If
several sensors are installed, touch the field to select the desired sensor.
5.2.7. Safety module
In the safety module, motion detectors and/or door contacts, for example, can be mon-
itored and specific alarm signals can be executed and/or alarm messages sent to email
addresses when they are activated.
System > Set screen > > Safety module
Name:
Displays the name of the safety module. Touch the field and enter the desired name
using the keyboard that appears.
