32
Installation and commissioning
CasaConnect KNX Control Center
• Version: 13.09.2021 • Technical changes and errors excepted.
3.1.
Procedure
Installation, check, installation and troubleshooting of the
control center may only be performed by an expert electrician
(according to VDE 0100).
1. The
installation
of the control center and the other KNX participants must be car-
ried out by an electrician. Information in the installation instructions, for example
also about the installation location, must be observed.
See this chapter.
2. After completing the installation work, the
KNX integration
in the control center
must be performed in the
ETS
.
See chapter 4 “Basic settings in the ETS” on page 39.
3. In the
System > Installation
menu, the control center have to be
fundamentally
set up
.
See chapter 5.2 “The "Set screen" menu” on page 76.
4.
Further settings
for time receipt, screen saver, network connection, access code,
updates etc. can be made at any time in the
System > System settings
menu.
See chapter 5.3 “System setting” on page 91.
5. The
Automatic functions
have to be adjusted in the
System > Set automatic
menu to the structural situation and the individual presettings of the users.
See chapter 6 “Automatic” on page 103.
3.1.1. Operating system
The
CasaConnect KNX
works with the Android operating system. However, the con-
trol center work independently so no third-party Apps may be installed!
3.1.2. Protective film
Remove the protective film from the display. Otherwise, there is a risk that the touch
operation will be deactivated. If this should happen, the control center must be restart-
ed so that the touch display works again.
3.1.3. Installation notes
Installation, testing, operational start-up and troubleshooting should
only be performed by an authorised electrician.
CAUTION!
Live voltage!
There are unprotected live components inside the device.
• Inspect the device for damage before installation. Only put undamaged
devices into operation.
