99
Basic settings in the Control Center
CasaConnect KNX Control Center
• Version: 13.09.2021 • Technical changes and errors excepted.
Save config.:
Touch the field in order to save the setting data for the control center on the SD card.
Select an existing configuration from the list in order to save it. Or add a new configu-
ration and enter the desired name it should be saved as.
Delete config.:
Touch the field in order to view all the configuration files in the card's master directory.
Touch an entry to delete the file (deletion must be confirmed).
Load auto backup:
Touch the field to restore a backup. Select the desired backup.
Show pictures on the display
The
CasaConnect KNX
can display digitally saved picture data as a slide show or a
single image. The picture data for this must be saved on an SD card.
Information about possible picture information can be found in chapter Set up screen, Page 92.
The sequence of the catalogue of individual images and of the slide show corresponds
to the sequence in which the images were saved onto the card. The images are not
sorted according to name.
To return to the start page, touch the screen or remove the SD card.
Slide show:
Touch the field to start the slide show. The images are displayed in the same sequence
as they were saved onto the card. The image changes approx. every 5 seconds (for im-
ages with 24-bit colour intensity).
Single picture:
Touch the field if you want to display a single picture. All pictures stored on the card
are displayed. Select the desired picture.
5.3.5. KNX bus
Individual address:
The individual address (KNX bus address) of
CasaConnect KNX
is displayed here.
When delivered, this is: 15.15.255.
Programming mode:
If programming mode is active, the individual address of the
CasaConnect KNX
can
be changed in the ETS.
