98
Basic settings in the Control Center
CasaConnect KNX Control Center
• Version: 13.09.2021 • Technical changes and errors excepted.
5.3.4. Use SD card
The card is detected automatically. If picture data is saved on the card, the "Slide show"
button is displayed on the right of the upper menu bar, with which you can directly
start it. The image changes approx. every 5 seconds (for images with 24-bit colour in-
tensity). To interrupt the slide show, touch the screen or remove the SD card.
Information about possible picture information can be found in chapter Set up screen, Page 92.
Save and load configuration data
The SD card is also used as a storage and transmission medium for setting data (all
settings in the menus "System", "Set screen" and "Set Automatic"):
•
for the automatic backup
•
to save the personal settings, for example a summer and a winter configuration
Backup function:
The configuration data for the control center is automatically saved as a backup on the
SD card supplied 5 minutes after each change (memory requirement approx. 5 MB).
When resetting to factory settings, the backup file is also overwritten after 5 minutes.
If you insert the SD card with the backup into a new/other device, you will be asked if
you want to load the backup.
You can also select the file with the file name "Auto_"Serial number"" in the menu area
System > System setting > SD card > Load auto-backup
and thus load the auto-
matically saved configuration data. The parameters for this are reloaded (provided the
functions of the respective channel are identical).
Load config.:
Touch the field in order to view all the configuration files in the card's master directory.
Touch an entry to load the file. The control center are restarted.
The
CasaConnect KNX Control Center
can load data from a micro SD
card.
System > System settings > SD card
The SD card storage is needed for:
•
Screen saver data
•
Update files for software updating
•
Saving settings (configuration file)
The card socket is located on the right-hand side of the device. The SD card
is pushed into the slot, until it clicks into place.
To remove, briefly press the card into the socket so that is jumps out.
