ELSA LANCOM Business 6000, Manual

Page: 92 / 174

Operating modes and functions
|
|
ELSA LANCOM Business 6000
|
92
EN
Use the channel list to determine the minimum and maximum number of B
channels to be used for the connection, which channels are to be connected
in which sequence, and the number of channels to be used as a dial-up
backup for a fixed connection if required.
Remote site
Name of the remote station as specified before in the name list.
Min
Minimum number of channels to be used to establish a connection.
If more than one channel is specified, static channel bundling will be
used for this connection. The layer to be used must be set up for bundling
in the layer-2 options.
Max
Maximum number of channels to be used to establish a connection.
If a larger maximum number of channels is stated than the minimum,
dynamic channel bundling will be used for this connection. The layer to
be used must be set up for bundling in the layer-2 options.
Order
The sequence in which connections for the individual channels are
established; stated with the syntax [Interface]-[Channel];[Interface]-
[Channel] etc.
Back-up Channels
Number of channels to be opened over dial-up lines when a leased line
is down.
6.8.8 Script
The script list in the ELSA LANconfig can be found in the 'Communication'
configuration section on the 'Protocols' tab, or under
/Setup/WAN-
module/Script-list
during Telnet or terminal sessions.
If the processing of a script is required to connect to a remote station, enter
the script here and assign it to a remote station.
The layer-3 protocol selected in the layer list for this connection must support
scripting.
Remote site
Name of the remote station as specified before in the name list.