ELSA LANCOM Business 6000, Manual

Page: 89 / 174

|
Operating modes and functions
89
|
ELSA LANCOM Business 6000
|
EN
The router interface settings determine the parameters to be used for each
dial-up interface while in router mode. These parameters do not apply to the
other operating modes of the units.
Specifically, they are:
Subscriber numbers (MSN/EAZ: terminal device selection numbers)
The router responds to incoming calls for these numbers. Multiple
numbers are separated by semicolons. If no number is specified, the
router will respond to all incoming calls.
The first number specified will be transmitted to the remote station
during the active establishment of a connection. If no number is
specified, the main MSN of the connection will be transmitted.
Call acceptance
Here you can restrict call acceptance to digital or analog calls.
Permit multiple simultaneous connections
Here you can specify whether multiple simultaneous connections to
differing remote stations are permissible. Disabling this option will
ensure that you always have channels free for connections to specific
remote stations.
Suppression of own subscriber number
Enable this option in order to suppress the display of your own subscriber
number to the remote station during call establishment.
This function must be supported by the network operator.
6.8.4 LANCAPI interface settings
The LANCAPI interface settings for the ELSA LANconfig can be found in the
'LANCAPI' configuration section on the 'General' tab, or under
/Setup/LANCAPI-module/Interface-list
during Telnet or
terminal sessions.