|
Appendix
31
|
ELSA GLADIAC 5II
|
EN
6
Appendix
6.1
CE conformity and FCC radiation standard
CE
This equipment has been tested and found to comply with the limits of the
European Council Directive on the approximation of the laws of the member
states relating to electromagnetic compatibility (89/336/EEC) according to
EN 55022 class B.
FCC
This equipment has been tested and found to comply with the limits for a
Class B digital device pursuant to Part 15 of the Federal Communications
Commission (FCC) Rules. The following procedures were applied during
conformity testing:
CE and FCC
These limits are designed to provide reasonable protection against radio
frequency interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy. It may interfere
with radio communications if not installed and used in accordance with the
instructions. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause interference to radio
or television reception (this can be determined by turning this equipment off
and on), the user is encouraged to try to correct the interference by one or
more of the following measures:
쎲
Reorient or relocate the receiving antenna.
쎲
Increase the distance between this equipment and the receiver.
쎲
Connect the equipment to an outlet on a circuit other than that to which
the receiver is connected.
쎲
Consult your dealer or an experienced radio/TV technician.
쎲
Caution: To comply with the limits for an FCC Class B computing device,
always use a shielded signal cable.
Caution to the user: The Federal Communications Commission warns the user
that changes or modifications to the unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
