ELSA ECOMO 21S99, User Manual, Page: 26 / 41

Technical Data
ELSA ECOMO 21S99
20
Power Management Function
The
ECOMO 21S99
complies with the guidelines set by VESA and Energy Star together
with the stringent standards of NUTEK. The
ECOMO 21S99
will automatically reduce
power consumption in three stages if the monitor is connected to a graphics board com-
plying with VESA DPMS. You can set the delay time before the monitor enters the power
saving mode using the on-screen menu (
➞
page 15).
The following table gives you an overview.
Factory Settings
To minimize the need for adjustment, the factory has preset popular display standards
into the monitor. Picture size and centering are automatically adjusted if any of these dis-
play standards is detected. All the factory presets may be overwritten by adjusting the
user controls. The monitor is capable of automatically storing up to 15 additional display
standards. The new display information must differ from any of the existing display stan-
dards by at least 1kHz for the horizontal scan frequency or 5 Hz for the vertical scan fre-
quency or the sync signal polarities must be different.
The VGA D-Shell Socket
Pin Assignment
Mode Synchronization Signal Power Con-
sumption
Recovery
Time
Power Indicator
Horizontal Vertical
Stand-by mode no yes
울
100W approx.
3sec
alternating green and
orange
Suspend mode yes no
울
15W approx.
3sec
alternating green and
orange
Active-off mode no no
울
5W approx.
10sec
Orange
Connection Signal Connection Signal
1 Red 9 +5 V
2 Green 10 Sync ground
3 Blue 11 Monitor ID2
4 Monitor ID0 12 Bidirectional data (SDA, DDC1/2B)
5 DDC ground 13 Horizontal synchronization
6 Red ground 14 Vertical synchronization
7 Green ground 15 Data timing (SCL, DDC2B)
8 Blue ground