ELSA ECOMO 117LCD, User Manual, Page: 20 / 42

Registration and Configuration
ELSA ECOMO 117LCD
14
Mode 2
The following parameters are automatically optimized during Auto-Setup:
쮿
CONTRAST and
쮿
BLACK-LEVEL
You should definitely run Auto-Setup in both modes before making any manual adjust-
ments.
Performing Auto-Setup in Mode 1
햲
Switch on the computer and the monitor
햳
Check the current resolution values. You can do this by selecting the INFORMATION
page on the OSD menu (
➞
page 19).
햴
Press both SELECT keys to switch off the OSD menu. The Auto-Setup function can
be performed only when the OSD menu is inactive.
햵
Place the enclosed diskette in the disk drive and start
햶
Press the RESET key. Auto-Setup will start up and automatically configure the set-
tings for the monitor's display within approx. 30 seconds. During this time the mes-
sage AUTO SETUP will blink on your monitor.
Please note that Auto-Setup works only with the pattern on the test picture. Displaying
the OSD menu or other components of programs during Auto-Setup can lead to unsatis-
factory results.
After the process has completed, press either a mouse button or a key on the keyboard
to end the test program. You may then remove the diskette from the drive.
If Auto-Setup does not determine the correct display settings even after several runs, you
must perform the adjustments manually. To do this you must also start the test program
as under
햵
. Proceed as described on page 18, 'Parts of the display on the monitor are
flickering or blurry' .
Performing Auto-Setup in Mode 2
햲
Place the enclosed diskette in the disk drive and start
under Windows under the Macintosh operating system
the file
TESTPRN.EXE
the 'test-mac' program on your desktop. Note that 'PC Exchange'
must be installed on your system.
under Windows under the Macintosh operating system
the file
TESTPRN.EXE
the 'test-mac' program on your desktop. Note that 'PC Exchange'
must be installed on your system.