Device description
elrest
Automationssysteme GmbH
e
VISIO PTE715_Windows.EN
Page: 20
For all signal connections are allowed only protected lines.
•
All plug connectors must be screwed or locked;
•
Signal lines and high-voltage cables are not allowed to lead both in the same cable duct;
•
For malfunctions and damages caused by the use of unsuitable cable, no liability can be
accepted;
•
Unused signals (e.g. unused interfaces, battery connections, etc.) have to be adequate
covered to avoid electrostatic influences (ETUC/ESD);
•
Cables only plug in/off when the device is turned off.
•
During the operation, all connected cables must be connected to a remote peer.
2.2.3
Connection to other elrest master -devices
For the Ethernet-interface X2 can be used commercial RJ45-plugs (8- pol) of good quality.
High quality
CAT-V cables are recommended.
Establish the connection as follows:
Order
number:
24BF1.D001
Accessories
23113.000x or 25150.0xxx
Designation
PTE715
Patch cable
RJ-45 to RJ-45
Combo master
CM2xx
Robusto master
RMC5xx
The individual accessory components can be taken from the chapter
.
Figure 6: Connection to other elrest master -devices
