905U-L Wireless I/O Installation Manual
905U-L Wireless I/O
Page 35 of 40
Version 1.9
Configuring your units
You can configure your network using:
Default factory configuration
– that lets you easily setup your network as a simple
send/receive; or
User-defined customized configuration
– that lets you set specific information
about your network and allows communication with other ELPRO 905 series devices.
For more information on setting a user-defined customised configuration, see the
User
Manual
.
For more information on setting the factory default configuration, refer to the
Quick Start
Guide
included with your module.
The following table details the factory default configuration:
Signals sent over radio
905U-L-T(Transmitter)
Sends
905U-L-R (Receiver)
Digital Input 1
Digital Output 1
Digital Input 2
Digital Output 2
Analog Setpoint
Digital Output 3
Analog input (4-20 mA)
Analog output
Other signals
905U-L-T(Transmitter)
905U-L-R (Receiver)
Thermocouple Input (Not used)
Communication Failure
(Comes on if no messages from 905U-LT)
Setpoint Output (Local indication)
System OK (On if system OK)
System OK
(On if system OK)
