User Manual
Condor 415U-1-Cx Battery Powered Wireless IO
Version 1.4
18
Display Units:
Sensor value units that are displayed within the configuration menu internally.
Display Scaling:
Allows scale multiplier to be applied to the sensor value that is displayed within the
unit. This can be used to scale to engineering units. This value is a float so will allow fractional scaling.
Report Sensitivity:
Sensor value change before a change of state event is generated. This value is a
float, so fractional values are allowed. Typical Input configuration below.
I/O Quick Setup
Using the I/O Quick Setup option in the Unit Configuration menu is the easiest way to quickly setup
the I/O and can be done for multiple units using multipliers. This can be used a basis for most
applications and then the sensor inputs and discrete output can be tailored to fit with the application.
Selecting I/O Quick Setup option in the Unit Config Menu will step through the Setup options (shown
below):
First a Multiplier will need to be configured which is an offset value that will be applied to the I/O so as
to offset the Destination Address in the AP where the I/O value will be stored.
It will automatically setup Digital Inputs 1 & 2 as Pulsed inputs, and Digital inputs 3 & 4 as ON/OFF.
The analog inputs will be setup as standard ELPRO 4-20mA and will prompt for a Sensitivity value for
each, which is the number of bits the analog needs to change before triggering a COS message to be
sent, default is 1000.
Then it will prompt for a Sample time (default 15 mins) and an analog warmup time (default 10 Sec).
