Elpress LDC-Q, User Manual

Page: 7 / 36

User manual & technical documentation – LDC-Q – EN – Rev 1.1 - 20022018
7
Instruction table
LD
C
-Q
LD
C
-Q
RF
LD
C
-Q
RFD
Rinsing generally
•
Before commencing with cleaning activities, connect the
installation according to the instructions in the section:
Installation requirements
• When the personnel start on the cleaning activities, a pressure drop in
the pipework causes the pump to start.
•
The installation will now start running in order to generate the set
pressure within the capacity curve of the pump.
•
In the break tank version, the pump will stop when the two level
switches at the top have not responded after a set time. A pump without
a break tank stops when the flow sensor emits a no-flow signal. In both
cases, the pump then switches to stand-by mode.
√ √ √
Satellite: Closed
• When no cleaning activities are being performed, the lever on the
Blocksat must be in the stop position (grey).
[3]
√ √
Satellite: Rinsing
• Connect the rinsing lance (blue) to the ball valve or to the spray gun.
•
Set the lever to the rinse position (blue). [4]
•
Start rinsing.
• After rinsing, always set the lever to the stop position (grey). [3]
√ √
Satellite: Foaming
•
Insert the connection hose (white) into the jerry can containing the foam
cleaning agent.
•
Connect the foam lance (white) to the ball valve or to the spray gun.
•
Set the lever to the foaming position (white). [5]
• Start foaming.
•
After foaming, always set the lever to the stop position (grey). [3]
The foam quality should be adjusted during commissioning. To adjust the
foam settings, go to the section: Changing settings.
√ √