PRODUCT USE, CARE AND SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
FOR YOUR OWN SAFETY
1. Read all instructions before using the fan heater.
2. Only connect the fan heater to a single-phase socket with a main voltage as specified
on the rating plate.
3. This appliance meets the electromagnetic compatibility requirements specified in EN
55104/95 with regard to interference with radio and TV sets.
4. Do not leave home while the appliance is in use: ensure that the switch is in OFF (“O”)
position and the thermostat is in minimum position.
5. Keep combustible material such as furniture, cushions, bedding, paper, clothes,
curtains etc. At least 100cm away from the fan heater.
6. Always unplug the heater when not in use. Do not pull the cord to unplug the heater.
7. Keep the air inlet and outlet free from objects: at least 100cm in front and 50cm behind
the heater.
8. Do not install the heater right below a socket.
9. Do not let animals or children touch or play with the fan heater. Pay attention! The air
outlet gets hot during operation(more than 80 ,or 175F).
10. Do not cover. For risk of overheating.
11. Do not use the fan heater in the rooms with explosive gas or while using inflammable
solvents, varnish of glue.
12. If the cord of this appliance is damaged discontinue use of this product and contact
the manufacturer for further instructions.
13. Keep the fan heater clean. Do not allow any objects to enter any ventilation or exhaust
opening as this may cause electric shock, or fire or damage to the heater.
INSTALLATION
The appliance requires no installation; it should be used solely as a portable appliance.
Portable appliances are not suitable for use in a bathroom.
OPERATION
-Turn the thermostat knob (right) in a clockwise direction until it reaches the maximum
setting.
-Summer service (ventilation only): turn the knob to setting ‘ * ’.
-Heating at reduced power: turn the knob (right) to setting ‘•’ (1000W).
-Heating at full power: turn the knob (right) to setting ‘••’ (2000W)
-Switching off: turn the knob (left) to setting ‘O’
